Table of Contents
Advertisement
1. Technical data
1.1 Functional description
The compact design of the control unit can supply all control units up to a load current of 6
ampere. It is intended for individual installation directly at the oscillating drive and
completely pluggable. The correcting range for the potentiometer in the front plate has been
adjusted in the factory at a reference drive and allows the adjustment of the output voltage
from 40 to 208 volts eff.
The illuminated rocking switch in the front plate separates the control unit with 2 poles from
the mains. For frequent switching or operation with a superordinate control unit there is the
possibility of wattless disconnection by means a potential-free contact as well as by 16-
30VDC voltage signal.
When the time (approx. 0.5 seconds) adjusted after turning the power on has passed, the
power is supplied. The time can be adjusted if necessary.
1.2 Technical data
Mains connection
Output voltage
Load current
Operating modes
Operating mode selection
Function release
Release by external signal
Soft start
Insulation type
Radio interference suppression
Dimensions
Part Feeding 7.0 Hopper & Hopper Controller Rev.5
230 Volt AC, 50 or 60 Hz, +10 −15% or
115 Volt AC, 60 or 60 Hz, +10 −15%
40...208 Volt (eff.) adjustable, (230 V mains)
20...105 Volt (eff.) adjustable, (115 V mains)
max. 6 Amp.(eff)
1. symmetric full wave operation
(oscillating frequency = double mains frequency)
2. asymmetric half wave operation
(oscillating frequency = mains frequency
Encoding bridge in the load plug
selectable by internal jumpers
Reverse battery protected input, level 16...30 VDC
at 24 Volt approx. 8 mA
Internally adjustable, standard approx.. 0.5 sec.
IP54
according to EMV - regulations
104 × 213 × 153 (width × height × depth)
1. Technical data
23
Advertisement
Table of Contents
