用 ご注意 電源電圧で使用しない。(やけど・故障の原因) 前 使用した場合、安全装置が働き、運転が停止します。 に 運転が停止したときは、すぐにメインスイッチを「OFF」にし、電圧切換 スイッチを「200/240V」に合わせ、数分間待ってから運転してください。 電圧切換スイッチを「200/240V」に合わせたまま100~120Vの ● 電源電圧で使用しない。 十分な温風が出ず、乾燥・セットに時間がかかります。 メインスイッチを「OFF」にし、電圧切換スイッチを「100/120V」に 合わせ、運転してください。 ● C-2プラグアダプター コンセントの形状がC-2タイプのときに ご使用ください。 ページ ● ユニット清掃ブラシ ページ ● 取扱説明書(保証書付) 中国語の取扱説明書(簡易版)はWebからダウンロードしてご覧いただけます。 Please refer to the web site of SHARP for the operation manual in Chinese. http://cs.sharp.co.jp/select/download?productId=IB-HD16...
The plasmacluster is discharged always while operating the dryer. * 1,2 Based on the investigation by SHARP NOTE • Please refer to the web site of SHARP for the operation manual in Chinese. • http://cs.sharp.co.jp/select/download?productId=IB-HD16...
Page 17
● Do not put foreign objects such as hairpin or wire from the air inlet/outlet. It could cause fire, electric shock or abnormal operation. ● Stop using immediately and contact shop or the customer service center of SHARP for repair in any of the cases below. If not, fire, electric shock or burning could be caused.
Page 18
英語翻訳 English How to use Please confirm that the voltage switch is at a correct position. In case of using with the voltage switch at "100/120V" and power voltage of 200~240V, the safety device works and the operation stops. When the operation stops, set the main switch to "OFF", set the voltage switch to "200/240V", wait for a few minutes, and then operate again.