Fcc Statement - Bosch D-tect200C Operating/Safety Instructions Manual

Dtect200C_2610067510_01-22.qxp_D-tect200 1/18/22 1:43 PM Page 9
Under abusive conditions, liquid may be ejected
from the battery; avoid contact. If contact
accidentally occurs, flush with water. If liquid
contacts eyes, additionally seek medical help.
Liquid ejected from the battery may cause irritation
or burns.
Do not use a battery pack or tool that is damaged
or modified. Damaged or modified batteries may
exhibit unpredictable behaviour resulting in fire,
EXPLOSION or risk of injury.
Do not expose a battery pack or tool to fire or
excessive temperature. Exposure to fire or
temperature above 265 °F (130 °C) may cause
explosion.
Follow all charging instructions and do not charge
the battery pack or tool outside the temperature
range specified in the instructions. Charging
improperly or at temperatures outside the
specified range may damage the BATTERY and
increase the risk of fire.
The manufacturer is not responsible for radio
interference caused
modifications to
modifications could void the user's authority to
operate the equipment.
This device complies with Part 15 of the FCC
Rules. Operation is subject to the following two
conditions:
1) This device may
interference, and
2) This device must accept any interference
received, including interference that may
cause undesired operation.
NOTE! This equipment has been tested and
found to comply with the limits for a Class B
digital devices, pursuant to Part 15 of the FCC
rules. These limits are designed to provide
reasonable protection
interference in a residential installation. This
equipment generates uses and can radiate radio
frequency energy and, if not installed and used
in accordance with the instructions, may cause
harmful interference to radio communications.
However, there is no guarantee that interference
will not occur in a particular installation. If this
equipment does cause harmful interference to
radio or television reception, which can be
General Safety Rules

FCC Statement

by unauthorized
this equipment. Such
not cause harmful
against harmful
Disconnect the battery pack from the tool before
making any adjustments, changing accessories, or
storing the tool. Such preventive safety measures
reduce the risk of starting the tool accidentally.
Do not modify or attempt to repair the tool or the
battery pack except as indicated in the
instructions for use and care.
Service
Have your tool serviced by a qualified repair
person using only identical replacement parts.
This will ensure that the safety of the tool is
maintained.
Develop a periodic maintenance schedule for
tool. When cleaning a tool be careful not to
disassemble any portion of the tool since internal
wires may be misplaced or pinched or may be
improperly mounted. Certain cleaning agents such
as gasoline, carbon tetrachloride, ammonia, etc.
may damage plastic parts.
SAVE THESE INSTRUCTIONS
determined by turning the equipment off and on,
the user is encouraged to try to correct the
interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation
equipment and receiver.
• Connect the equipment into an outlet on a
circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV
technician for help.
"Exposure to Radio Frequency (RF) Signals: The
wireless device is a radio transmitter and
receiver. It is designed and manufactured not to
exceed the emission limit for exposure to radio
frequency (RF) energy set by the Ministry of
Health (Canada), Safety Code 6. These limits are
part of comprehensive
established permitted levels of RF energy for the
general population.
These guidelines are based on the safety
standards previously
standard bodies. These standards include a
substantial safety margin designed to assure the
safety of all persons, regardless of age and health.
-9-
between the
guidelines and
set by international