Table of Contents
Advertisement
Dispense hot water
"Refill" position
18
All manuals and user guides at all-guides.com
Place the vessel at the dispensing position and dispense hot water.
Beep
Lock
Press
Unlock
Unlock lamp lit
Flow
Press
Control
The dispensing quantity can be adjusted by the force
with which the button is pressed.
¥ Strong: Strong flow
¥ Weak: Weak flow
Locking will be done automatically about 10 seconds after
the end of dispensing.
The unlock lamp goes out and no hot water will be dispensed
even when the
¥ To lock the button immediately after dispensing water.
Press the
Note:
¥ For some time after boiling, bubbles from the boiling may
get into the pump and dispensing may be impaired.
This can be corrected by opening and closing the lid.
* Watch out for the steam when opening the lid.
Refill before the "Refill" position is reached.
Caution:
¥ Do not leave the jar pot standing with an open lid.
(This may cause the function for prevention of empty
heating to operate.)
Empty the jar pot when it is not being used.
Disconnect the plug and remove the lid.
Discharge from the discharge position.
Caution:
¥ Do not discharge hot water from the operation side.
(This can cause trouble.)
¥ Do not leave water in the inner container. (This can cause
rust and/or smell.)
Note:
¥ When there is still a remaining charge after the plug has
been pulled, the temperature indication will appear.
to unlock the flow control pad.
to dispense hot water.
Flow
button is pressed.
Control
Lock
. The unlock lamp will go out.
Unlock
Refill when the water level has dropped.
Advertisement
Table of Contents
