Setting Up Instant Mymedia - Fujitsu Lifebook N3510 User Manual

To connect an S-Video cable:
The S-Video connector is keyed so that it can only be inserted when it is aligned
properly with the port. Be sure to examine the orientation of the connector with
the port before inserting it. Forcible insertion may cause damage to the connector
and/or port.
1. Connect the cable to the video output jack on the external device.
2. Connect the cable to the video input jack on the notebook (See Figure 12).
3. Connect the audio cable between the external device and the notebook, as described in
"Connecting an External Audio Device" on page 15.

SETTING UP INSTANT MYMEDIA

When using Instant MyMedia for the first time, setup will begin automatically after Instant
MyMedia is activated. Follow the steps below to complete installation.
When performing the installation, do not wear headphones initially; the volume
may be greater than expected.
Be sure to follow the steps indicated below. Attempting to install Instant MyMedia
using different steps could result in failure to start. If Instant MyMedia fails to start
after following these steps, refer to the Troubleshooting section of this manual.
1. Verify that the system is not powered on, then press the MyMedia button on the remote
control. During the first portion of the installation, the notebook will cycle through sev-
S-Video Cable
Figure 12. S-Video Cable Connection
S-Video Port
17