Assembly; Operation - Husqvarna DM400 Operator's Manual

• Maintain power tools and accessories. Check for
misalignment or binding of moving parts, breakage
of parts and any other condition that may affect the
power tool's operation. If damaged, have the power
tool repaired before use. Many accidents are caused
by poorly maintained power tools.
• Keep cutting tools sharp and clean. Properly
maintained cutting tools with sharp cutting edges are
less likely to bind and are easier to control.
Introduction
WARNING: Read and understand the safety
chapter before you assemble the product.
WARNING: To prevent injury, disconnect the
power cord and remove the drill bit before

assembly.

To do before you operate the product
1. Read the operator's manual carefully and make sure
that you understand the instructions.
2. Read the operator's manual for the drill stand
carefully and make sure that you understand the
instructions.
3. Use personal protective equipment. Refer to
Personal protective equipment on page 10 .
4. Make sure that the nominal voltage in the mains
socket is the same as the voltage of the product.
5. Make sure that the work area is clean and bright.
6. Make sure that the product is installed correctly. The
drill bit and the drill stand must be attached correctly.
(Fig. 10)
7. When you do inverted drilling, make sure that you
comply to the applicable instructions. Refer to
prepare the product for inverted drilling on page 12 .
8. Make sure that the water system is not damaged
and that it is connected to the product.
9. Do the daily maintenance. Refer to
schedule on page 14 .
10. Make sure that the PRCD is started. Refer to
on page 11 and To examine the PRCD on page 11 .
To use embedded connectivity
Note: This part is applicable only for products supplied
with embedded connectivity.
12
•
Assembly
To attach the product to a drill stand
•
•

Operation

Note: Radio transmission by the Bluetooth
be enabled on the first time of connection to a power
outlet, and stay on after that.
1. Download the Husqvarna Fleet Services iOS or
2. Go to Husqvarna Fleet Services website https://
To prepare the product for inverted
drilling
To
1. Clean the top of the slurry ring. All grease and dirt
2. Attach 2-sided adhesive tape or use spray glue
Maintenance
PRCD
3. Look for the dimension of the core drill on the top of
4. Cut a hole in the sealing disc in the nearest smaller
5. Attach the rubber washer to the quick-release
6. Connect the slurry collector to the connection of the
Have your power tool serviced by a qualified repair
person using only identical replacement parts. This
will ensure that the safety of the power tool is
maintained.
CAUTION: Read the operator's manual for
the drill stand carefully.
To attach the product to a drill stand, refer to the
manual for the drill stand.
Use only with approved Husqvarna drill stands.
Accessories on page 19 .
Refer to
Android app Husqvarna Fleet Services.
fleetservices.husqvarna.com for more information.
WARNING: Always use a slurry ring with a
sealing disc and a rubber washer during
inverted drilling. Water that enters the
product increases the risk of electrical
shock.
must be removed.
around the top opening of the slurry ring (A). Put the
sealing disc on the top opening as a cover (B).
Attach it tightly. (Fig. 11)
the drill. (Fig. 12)
dimension as the core drill. (Fig. 13)
washer on the drill spindle. (Fig. 14)
slurry ring. (Fig. 15)
®
function will
1188 - 008 - 14.09.2020