Cleaning and maintenance
en
Filter in the water supply
blocked
First, reduce the water pressure in the
supply hose:
Turn off the tap.
1.
Select any programme
2.
(except Rinse/Spin/Empty).
Press the A button. Allow the
3.
programme to run for approximately
40 seconds.
Press the # button. The appliance is
4.
switched off.
Pull out the mains plug.
5.
Then clean the filter:
Disconnect the hose from the tap.
1.
Clean the filter with a small brush.
For standard and Aqua-Secure
2.
models, clean the filter on the rear of
the appliance:
Remove the hose from the rear of
the appliance.
Use pliers to remove the filter and
then clean it.
Connect the hose and check for
3.
leaks.
54