Remote Control; Remoteupdate - Miele PFD 104 SCVi Operating Instructions Manual

Settings 
Network configuration
You can use this menu option to reset
all Wi-Fi module settings (if available) to
the factory default settings.
The network configuration should be
reset whenever a dishwasher is being
disposed of or sold, or if a used
dishwasher is being put into operation.
This is the only way to ensure that all
personal data has been removed and,
in the case of the latter, a previous
owner will no longer be able to access
the dishwasher.

Remote control

This menu option will only be
displayed if you have connected your
dishwasher to your Wi-Fi network (see
"Settings - Miele@home").
If you wish to permanently switch off
the
Remote control
this under this menu option. The
 sensor will then no longer be
available to select until you change this
setting again.
Even if the Remote control
switched off, you can use the
Miele@mobile App to call up
information about your appliance.
However, you cannot start any
programmes or change any settings
from it.
104
option, you can do
option is

RemoteUpdate

The RemoteUpdate menu option is
only displayed and can only be
selected if the requirements for using
Miele@home have been met (see
"Using for the first time -
Miele@home").
The RemoteUpdate function is used for
updating the software in your
dishwasher. If an update is available for
your dishwasher, it will automatically
download it. Updates will not be
installed automatically. They must be
initiated manually.
If you do not install an update, you can
continue to use your dishwasher as
usual. However, Miele recommends
installing updates.
Activating/Deactivating
The RemoteUpdate function is
activated as standard. Available
updates will be downloaded
automatically but will only be installed if
you initiate the installation manually.
Deactivate RemoteUpdate if you do not
want any updates to be downloaded
automatically.