Panasonic AVC ULTRA AJ-UPX36OED Operating Instructions Manual page 45

Memory card camera-recorder
Table of Contents

Advertisement

1 Volume label of the memory card
2 Video data in MXF format (audio: LPCM)
3 Meta data in XML format
4 Thumbnail in BMP format
5 The file to which the information of the final clip was recorded
6 Video data in MOV format: UHD (3840×2160), 29.97P MOV (audio: LPCM)
7 Video data in MOV format: FHD (1920×1080), 59.94i MOV (audio: LPCM)
8 Management file 1
9 Management file 2
10 Thumbnail of video data
11 Video data in AVCHD standard (00000.MTS, etc.)
12 Management folder
@
NOTE
t Do not erase a folder or file on the memory card with a computer. It may make it impossible to load on the camera.
t If data is recorded to the memory card with a computer, an error may occur such as an inability to recognize or record to the memory card with the
camera.
t The memory card to use with the camera should always be formatted on the camera.
t The number of the P2 format clips that can be recorded on a single memory card is 1000, and the AVCHD format clips is approximately 3900.
Data will not be able to record when it reaches the maximum number of data that can be recorded.
t When transferring a recording data in a P2 format to a computer, or when writing back to a microP2 card, be sure to use the dedicated software "P2
Viewer Plus" to prevent data loss. For details on downloading P2 Viewer Plus and the operating environment, visit the support desk at the following
website:
https://pro-av.panasonic.net/
t Follow the instructions below when using a general IT tool such as the OS standard file manager equipped on a computer to transfer a recording data
in P2 format to a computer. However, be sure to use P2 Viewer Plus when returning data back to a microP2 card.
‑ Perform the transfer for each CONTENTS folder and LASTCLIP.TXT file.
‑ Do not operate the folders under the CONTENTS folder.
‑ When copying, copy the LASTCLIP.TXT file at the same time as the CONTENTS folder.
‑ When transferring the data in multiple microP2 cards to a computer, create a folder for each memory card to prevent clips with the same name from
being overwritten.
‑ Do not delete data inside a memory card.
‑ Be sure to format the memory card with a P2 device or P2 Viewer Plus.
Chapter 3 Preparation — Preparing the memory card
B002
CONTENTS
AVCLIP
AUDIO
CLIP
ICON
PROXY
VIDEO
VOICE
LASTCLIP.TXT
PRIVATE
PANA_GRP
001RCQAM
002YCJAM
BACKUP.TMP
INDEX.DAT
AVCHD
AVCHDTN
BDMV
PANA_EXT
– 45 –
1
2
3
4
5
6
7
8
9
10
11
12

Advertisement

Table of Contents
loading

This manual is also suitable for:

Avc ultra ag-cx350

Table of Contents