Replacement Of Worn Parts; Replace The Pressure Point Of The Fi Ngers In The Rotary Table (Only Sizes 1 And 2) - Bosch Rexroth HD 2/H Assembly Instructions Manual

Please note:
• Perform the replacement
at the upper end position
of the lift rotate unit.
• The rotating cylinder
must be depressurized
(vented).
Required tools
• Hex socket head cap
screw SW6
• Strainer
1. Remove the latch (A)
from the rotary table.
2. Remove the fi nger (B)
3. Replace the pressure
point (C).
4. Lubricate the pressure
point.
5. Reassemble the fi nger
and the latch.

10.4 Replacement of worn parts

Required tools
• Hex head cap screw SW13
• Hex socket head cap screw SW3, SW4, SW5, SW6.
• Cross recess screwdriver PZ2
• Calipers, 500 mm
• Rubber mallet
• Strainer
10.4.1 Replace the pressure point of the fi ngers in the rotary table
(only sizes 1 and 2).
5
C
4
B
ISO-FLEX
TOPAS
NCA 52
Fig. 28: Exchange the pressure point of the fi ngers in the rotary table (only sizes 1 and 2).
Maintenance and repair
5
1
2
3
3 842 358 796/2015-01, MIT: HD 2/H, Bosch Rexroth AG
47/56
2x
SW6
M =8 Nm
D
A
358 732-16