Display And Operating Components; Display; Setting The Brightness; Fig. 6-1: Values For The Representation Type - Bosch Rexroth IndraControl VCP 35.2 Project Planning Manual

R911323106 / 02 | Rexroth IndraControl VCP 35.2

Display and Operating Components

6 Display and Operating Components
6.1

Display

6.1.1

Setting the Brightness

Danger of intoxication!
If the display is damaged, avoid touching, swallowing or breathing in the
liquids or gases which may leak out.
Danger of corrosion!
If the display is damaged, avoid touching, swallowing or breathing in the
liquids or gases which may leak out.
The small operator terminal VCP 35.2 is equipped with a TFT-Display.
To be able to set the brightness, you need to use the programming
software to setup the system variable LcdBackLight in a screen of
your choice.
To do so, follow the instructions listed in the programming software's
help topic "How do I specify the contrast / brightness setting for the op-
erating device".
In the programming software, enter the following values as lower and
upper limits for the representation type.
System Vari- Lower Limit
able
LcdBackLight

Fig. 6-1: Values for the representation type

If you do not configure the system variable LcdBackLight, the default
setting is used when the device is initialized.
Adjust the brightness to the surrounding conditions at reached operat-
ing temperature to be able to read the display optimally.
If you did set up the system variable, you can set the brightness as fol-
lows. Open the screen where you set up the system variable and:
1. Press the button for brightness.
2. Enter a new value for the brightness. To do so, use the virtual key-
board.
3. Confirm with Enter.
The new brightness setting becomes effective immediately after the
Electric Drives and Controls | Bosch Rexroth AG
Upper
Limit
+ 1 + 31
6-1
Default Set-
ting
+ 15