Panasonic DMR-BWT760 Operating Instruction page 80

TV reception is not displayed.
• Broadcast signals are not output from this unit's
RF OUT terminal. Select "On" in "RF OUT
( Aerial Signal )". (
The screen changes automatically.
• If "Screen Saver" set to "On", the screen saver
function will be activated when there is no
operation for 5 minutes or more. (
There is a lot of image lag when playing video.
• Set to "0" all items in the "Noise Reduction".
( 40)
• Set "Audio Delay". (
The images do not appear on the TV.
The picture is distorted during play, or video
is not played correctly.
• Check the connections. (
• Check the settings of the connected TV, etc.
• An incorrect resolution is selected in "HDMI
Video Format". ( 74) Reset the setting as
follows:
1 While the unit is on, press and hold [OK], the
yellow button and the blue button at the
same time for more than 5 seconds.
• "00 RET" is displayed on the front panel
display.
2 Repeatedly press [1] (right) until "04 PRG"
is displayed on the front panel display.
3 Press and hold [OK] for at least 3 seconds.
Set the item again.
• When Dolby Digital Plus, Dolby TrueHD,
and DTS-HD audio are not output
®
properly, select "Yes" in "Default Settings"
and make proper settings. (
• The unit's TV System is different from that of the
disc. Change the TV System. (
System)
• The picture may be distorted or a black screen
may appear between scenes recorded with
different aspect ratios.
• Set "Deep Colour Output" (
Type Flag" ( 75) to "Off".
• The country setting is not set correctly. Perform
"Shipping Condition" (
the country you live in again.
80
SQT1109
77)
74)
74)
9)
78)
74, TV
75) or "Contents
78) first, and then set
3D video is not output correctly.
• 3D video may be output correctly by changing
the following settings:
- "3D Type" of "3D Settings" (
- "Signal Format" (
playback)
• Check the settings of the connected TV.
• When a non-3D compatible amplifier/receiver is
connected between this unit and a TV, 3D video
is not output. ( 10)
• When "HDMI Audio Output" is set to "Off", 3D
video may not be output correctly. (
Sound
No sound.
Distorted sound.
• Check the connections. (
• Check the settings of the connected TV, etc.
• Press [AUDIO] to select the audio. (
• To output audio from a device connected with an
HDMI cable, set "HDMI Audio Output" to "On".
( 75)
Cannot change audio channel.
• You cannot change the audio channel if "Digital
Audio Output" is set to "Bitstream". (
Recording, timer recording and
copying
Cannot record.
Cannot copy.
• Some broadcasts are copyright protected.
• You cannot record to the disc by pressing the
[REC ¥] or timer recording.
• The disc is protected. (
• [DVD-R] [DVD-RW] [+R] [+RW] Since it will copy to
HDD temporarily, copying is not possible if there
is insufficient available capacity on the HDD.
• This unit cannot record/copy NTSC signals to
discs that already have PAL signal recordings.
74)
38, 3D settings during
75)
9)
21, 37)
73)
67)