Haier HNS1260TVE Service Manual page 20

Error message. Motor overheat protection or damaged.
Troubleshooting:
Cut off power and check if motor wires
are connected well
Y
Measure if resistance of motor winding by
multimeter, is it as followed?
1-2(between white and white):5
3-5(between brown and red):3.4
7-8(between grey and black): 4 0
Y
Pull out the wire connection of motor
Then check if circuit is open by multimeter
Front Load Washing Machine
1
2
3
5
7
8
Repair wires
Y
Page 19
Model:
Reconnect well
N
Put the motor in normal temperature about
ten minutes, and then test again. If the
N
resistance is natural, it is caused by
overheated protection. Then check and
deal with overload, abnormal voltage. If
not, please replace motor
HNS1260TVE/ME