Table of Contents
Advertisement
Installation
Note:
• Before finally installing the unit, connect the
wiring temporarily, making sure it is all con-
nected up properly, and the unit and the system
work properly.
• Use only the parts included with the unit to
ensure proper installation. The use of unautho-
rized parts can cause malfunctions.
• Consult with your nearest dealer if installation
requires the drilling of holes or other modifica-
tions of the vehicle.
• Install the unit where it does not get in the dri-
ver's way and cannot injure the passenger if
there is a sudden stop, like an emergency stop.
• When mounting the AV Receiver, make sure
none of the leads are trapped between the AV
Receiver and the surrounding metalwork or fit-
tings.
• Do not mount the AV Receiver near the heater
outlet, where it would be affected by heat, or
near the doors, where rainwater might splash
onto it.
• Before drilling any mounting holes always
check behind where you want to drill the holes.
Do not drill into the gas line, brake line, electri-
cal wiring or other important parts.
• If the AV Receiver is installed in the passenger
compartment, anchor it securely so it does not
break free while the car is moving, and cause
injury or an accident.
• If the AV Receiver is installed under a front
seat, make sure it does not obstruct seat move-
ment. Route all leads and cords carefully
around the sliding mechanism so they do not
get caught or pinched in the mechanism and
cause a short circuit.
• Do not place the display in a position where it
will impede the driver's visibility or affect the
operation of your vehicle's air bags.
• The semiconductor laser will be damaged if it
overheats, so don't install the unit anywhere hot
— for instance, near a heater outlet.
• If installation angle exceeds 30° from horizon-
tal, the unit might not give its optimum perfor-
mance.
163
Installing the AV Receiver
7 Mounting with Brackets
Car mat or chassis
7 Mounting with Velcro Tape
Thoroughly wipe off the surface before affixing
the velcro tape.
Car mat or chassis
30°
Tapping screw (4 × 12 mm)
Bracket
Drill 2 to 2.5 mm (1/8 in.) diameter holes.
Velcro tape
(20 × 90 mm)
(3/4 × 3-1/2 in.)
Screw
(4 × 8 mm)
Advertisement
Table of Contents
