Silvercrest 300405 Operating Instructions Manual page 43

6) Clean the control/heating element
little mild detergent to the cloth. Wipe this off afterwards using a damp cloth
so that all detergent residue is removed. Dry the control/heating element
thoroughly.
NOTE
–
If you want to clean the permanent metal filter
lid
liquid.
–
Leave it for a moment to soak and sway it back and forth.
–
Then rinse the appliance lid
–
Dry it and place it upright on its side so that any excess water still
inside the appliance lid
–
Dry it again and make sure that there is no water remaining under the
rubber lip on the bottom of the appliance lid
rubber lip to dry it.
Make sure that the appliance lid
again!
7) Dry all parts well before Assembly.
8) Reassemble the deep fat fryer in the reverse order.
Storage
1) Lift or carry the appliance using the recessed grips
housing.
2) Wrap the power cable around the cable spool
Push one of the pins of the mains plug into one of the holes on the cable spool
to hold the mains plug in place.
3) Store the appliance with the appliance lid
inside of the deep fat fryer clean and free of dust.
■ 40 │ GB │ IE
, place the appliance lid
with a damp cloth. If necessary, add a
inside the appliance
in warm water with a mild washing-up
with clear water.
can drain away.
. If necessary, lift the
is completely dry before using it
on the rear of the appliance.
closed. This will keep the
on each side of the
SKF 2800 B3