GE Lumination L-TC-ID-A-1 J1 Series Installation Manual

GE
Lighting
Lumination
(LTC - Juno Adapter)
When installing or using this track system, basic safety precautions should always be followed, including the following:
1. Turn off power at fuse circuit breaker box before installation or before doing any maintenance work.
2. Wear rubber soled shoes and work on a sturdy wooded or non-conductive ladder.
3. Product must be mounted in location and at height in a manner consistent with its intended use, and in compliance with
National Electrical Code and local building codes.
4. For Indoor use only.
5. Do not exceed the nominal supply voltage or amperage ratings.
6. Do not install any lampholder closer than 6".
7. WARNING: Risk of fire. Most dwellings built before 1985 have supply wire rated at 60°C. Consult a qualified electrician before
installation.
8. CAUTION: To reduce risk of fire and electrical shock, use only fixtures and fittings intended for use with the single or 2-circuit,
120V systems.
9. The track and all components are rated for 120V, 20A capacity. (2400W max)
10. Do not exceed the nominal supply voltage or amperage rating.
11. To avoid hazard to children, account for all parts and properly dispose of all packing materials.
12. Read all instructions
13. Do not install this track in damp or wet locations.
14. Do not cut any track sections.
15. Do not install any part of a track system less than 5 feet above the floor.
16. Do not install any luminaire assembly closer than 6 inches from any curtain, or similar combustible material.
17. Disconnect electrical power before adding to or changing the configuration of the track.
18. Do not attempt to energize anything other than lighting track luminaires on the track. To reduce the risk of fire and electric
shock, do not attempt to connect power tools, extension cords, appliances, and the like to the track.
19. Do not connect a track to more than one branch circuit unless the track is constructed so that it can be used with more than
one branch circuit. Check with a qualified electrician. Although the track lighting system may seem to operate acceptably, a
dangerous overload of the neutral may occur and result in a risk of fire.
BEFORE YOU BEGIN
Read these instructions completely and carefully.
FOR USE WITH CEILING MOUNTED TRACK ONLY.
READ JUNO TRACK INSTALLATION INSTRUCTIONS
FOR GUIDELINES ON TRACK INSTALLATION.
imagination at work
LED Track Light
TM
IMPORTANT SAFETY INSTRUCTIONS
SAVE THESE INSTRUCTIONS
For future reference when adding fixtures
or changing the track configuration.
WARNING
RISK OF ELECTRIC SHOCK
Turn power off before inspection, installation or removal.
To reduce risk of fire and electric shock, use only with
Juno R, T or TU series track system.
SKU L-TC-ID-A-1-XX-XX-X-XX-X-X-J1-XXXX
120V
Input Voltage
60Hz
Frequency
Installation Guide
CAUTION