Care And Cleaning - Electrolux EA11S Manual

Storage with or without fridge
(available in some models only)
The water dispenser has a refrigerator
to store food and fruits in some
models.
To turn on the cooling system it is
necessary to activate the cooling
switch (green).
In non-refrigerated models there is a
hermetic storage cabinet. Do not store
any food at this non-refrigerated
storage.
When first time to utilize the
refrigerating function, let the
refrigerating function operated for at
least 2 hours before putting anything
into the cabinet.
No wet or hot goods is allowed to be
put into the cooling cabinet. Leave
suitable space between the goods to
ensure the interior airflow.
Important
• Food and fruits should not be
placed on non-refrigerated models
to prevent putrefaction.
11

Care and cleaning

This unit has been tested and sanitized prior to packing and shipping. During
transit dust and odors can accumulate in the tank and lines. Dispense and
dispose at least one quart of water prior to drinking any water.
Wipe with a soft, clean piece of cloth in part outside of water dispenser
regularly.
The water inside the bottle must not contain chlorine additive. So it's very
important that the inside of the water dispenser is sterilized and clean.
Do not touch the water outlet to avoid its contamination. The water reservoir
Storage
must be cleaned and sterilized every 3 months.
with fridge
(available
Water will fall from the water collector if it is completely filled with water, please
in some
empty the water collector periodically.
models only)
Never clean your water cooler with flammable fluids such as alcohol, kerosene,
gasoline, paint thinner, solvents, chemicals or abrasives as detergents, acids,
vinegar or products that might leave the smell.
Wipe the outside of the water dispenser with water and neutral detergent.
Do not use chemical cleaners or volatile solvents, because the product can
lose brightness and colour.
Procedure for cleaning & sterilization of the appliance
1. Disconnect the appliance from power source.
2. Remove the water bottle and empty water reservoir through pressing the
buttons until there is no water coming out.
3. Open the drainage cap, existing at the back of the dispenser, and ensure
that all the water flow out of the appliance.
4. Prepare a chlorinated solution (2 litres of clean water and 0.5 tea spoon of
bleach).
5. Place the chlorinated solution in an empty bottle of water and fill your water
dispenser.
6. Wait 10 minutes for the chlorinated solution take effect and remove all the
water through the drain.
7. Fill 1/3 of the bottle with clean water. Replace the bottle and remove all the
water by triggers and drainage cap. This will rinse the tanks and the triggers
of your product.
Warning
Always disconnect the water dispenser from power source before cleaning it or
doing any maintenance.
12