Converting to another gas type
To change the jet for the inner burner
d Jet disc (main jet for the inner
burner)
e Air intake sleeve
f Vent
Remove the screw from the fit-
ting with an SW 8 spanner while
counterholding it with an SW 12
spanner.
Remove the screw fitting from
part with an SW 12 spanner while
counterholding it with an SW 12
spanner.
Remove jet disc from fitting and
replace with the new jet disc (see jet
table).
Adjust air intake sleeve until the
two vents have a 2 mm gap, as il-
lustrated.
Reassemble the parts in reverse or-
der and carry out a leakage test.
60