Kenwood DM-SE7 Instruction Manual page 51

Other symptoms
Symptom
Sound is not output even when
the play key is pressed.
Recording is not possible
Sound is distorted.
Noise is noticeable.
*1
TOC : All minidiscs contain a Table of Contents (TOC) in addition to sound signals. The TOC is similar to the table
of contents in a book and contains information, such as track numbers, track length, and character
information, that cannot be rewritten.
*2
TOC : In addition to the TOC, minidiscs also contain a special User's Table of Contents (UTOC) that contains
track number, track length, and character information, that can be rewritten.
Cause
¶ The cords are connected errone-
ously.
¶ No disc has been loaded.
¶ A non-recorded disc has been
loaded.
¶ The disc is write-protected.
¶ An attempt is made to record digital
signal from a source while its digital
copy has been prohibited by SCMS.
¶ The recording level is too low (in case
of analog recording).
¶ A playback-only disc has been loaded.
¶ The disc does not have a recordable
area.
¶ The REC INPUT key is not set to the
actual input source.
¶ If the amplifier is connected to this unit
through a system control cord, the
amplifier's input selector is set to the
MD input.
¶ The recording level has not been ad-
justed.
¶ A disc in which distorted sound has
been recorded is played.
¶ An external noise is induced.
In case of difficulty
Remedy
¶ Connect the cords in accordance with
"System connections".
¶ Load a disc.
¶ Load a prerecorded disc or playback-
only disc.
¶ Change the position of the write
protect tab to the write position or
90
use a recordable disc.
¶ Use analog recording.
¶ Adjust the recording level again.
¶ Use a recordable disc.
¶ Use another disc.
¶ Set it according to the actual input
¢§
source.
¶ Set the amplifier's input selector to
other position than MD.
¶ Read "Adjust the recording level".
¶ Use another disc.
¶ Install the unit at a position apart
from an electric appliance or TV set.
51
DM-SE7(En)
@
&
¢
¢
0
¢
p
p