Page 3
Installing the Wire Harness 11. Feed the plugs from the front lights through to the roller plate and connect to the loom. 1. With the operator platform still in the raised position, route the wiring loom by feeding the longest section 12.
Page 5
2. 15 A Installing the Front Lights Kit 02845 is required for the T4240 so that the front lights can be clearly seen with the cutting units raised. To install the fitting kit 02845 with the lighting kit 02844 to a T4240 traction unit, follow these instructions.
1. In order to comply with the road vehicle lighting regulations adjust the front dipped beam headlights so Replace all worn or damaged parts with genuine Toro parts. that the horizontal part of the cutoff of the beam is inclined downward.
Page 8
Schematics g206693 Electrical schematic (Rev. A)