Programme Cancellations And Fault Messages - Miele PWM 908 Operating And Installation Instructions

Problem solving guide

Programme cancellations and fault messages

Problem

Drainage fault. Clean
drain filter and pump.
Check the drain
hose.

Water intake fault.
Turn on the tap.

Waterproof system
activated

Disinfection
temperature not
reached

Fault F. If restart
fails, call Miele.
60
Possible cause and remedy
The water outlet is blocked or restricted.
The drain hose has been fixed too high.
 Clean the filters and the drain pump.
 The maximum drain height is 1 m.
The water inlet is blocked or restricted.
 Check whether the tap is turned on properly.
 Check whether the inlet hose is kinked.
The water pressure is too low.
 Switch on the
"Supervisor level - Low water pressure").
The filters in the water inlet are blocked.
 Clean the filters (see "Cleaning and care - Cleaning
the filters").
The water protection system has reacted.
 Turn off the tap.
 Call Miele.
The required temperature was not reached during the
disinfection programme.
 The washing machine has not carried out the
disinfection cycle correctly.
 Start the programme again.
There is a fault.
 Disconnect the washing machine from the mains
electricity supply.
 Wait at least 2 minutes before reconnecting the
washing machine to the mains.
 Then switch the washing machine on again.
 Start the programme again.
If the fault message appears again, contact Miele.
Low water pressure setting (see