When Using The Appliance For The First Time; How To Use - Panasonic ES‑WH93 Manual

Table of Contents

Advertisement

When using the appliance for the first time

Check that the output level suits your skin.
Treated skin may temporarily turn red or feel painful
depending on the body type or condition of the person
using the appliance.
Set the output level to 1 (强度1) and flash the
treatment area once.
After 2 days
If there are no skin abnormalities
Set the output level to 1 (强度1) and start treatment
on the area that you want.
• Guide for treatment frequency, time (See page 31.)
If there are no skin abnormalities
After 2 weeks*
* For armpits/bikini line/face: after
1 week
To increase the output level for treatment, flash once
on the treatment area, and check your skin condition
for around 2 days before further treatment. Increase
the output level one step at a time.
• If there is intense pain or
redness after 2 or more
days, stop using the
appliance and consult a
dermatologist.
34
<Output levels>
Greater treatment effects
强度 5
强度 4
强度 3
强度 2
强度 1
Minimal pain or irritation

How to use

• The power will not turn on even when pressing the
switch with the AC adaptor connected to the main body.
• The appliance may not operate in an ambient
temperature lower than approximately 5 °C.
1
1
Remove the cap.
2
2
Attach the attachment to suit the area where you
want to use it.
3
3
Press and hold (for approximately 3 seconds)
to turn the power on.
• The power will turn off automatically if the appliance
is not used for approximately 1 minute.
4
4
Press
to select the output level.
• Level 1 is selected when the power is turned on.
• The level cycles through 1
each time the level selector switch is pressed.
• The level indication lamp blinks, and then turns on.
(A beep sounds, indicating that preparation for flash
is complete.)
2
3
4
5
1...

Advertisement

Chapters

Table of Contents
loading

Table of Contents