Epson Perfection 1270 Start Here

Start Here
Epson Perfection 1270 ® ®
Please read these instructions before using the product.
Unpack Your Scanner
1
Make sure you have everything for your Epson scanner:
Perfection 1270
Software
2
Remove all packing tape, but leave the large sticker in place.
IMPORTANT!
Leave the sticker in
place until you are
instructed to remove it
Install the Software
Wait! Install your software before connecting the scanner to your computer.
1
Insert the scanner software CD-ROM in the CD-ROM or DVD drive.
If the installer does not start automatically, do the following:
•
Windows XP: Start > My Computer > Epson.
•
Windows 98, Me or 2000: My Computer > Epson > Epson.
2
Follow the on-screen instructions to install the scanner software and
Reference Guide. Note that EPSON Smart Panel
Note: If you're using Windows 98 and you see a message asking if you'd like
to restart your system, select No, I will restart my system later.
3
At the end of the installation, click Exit.
4
When you see the Product Registration screen, register your scanner on-line
as instructed.
Connect the Scanner
1
Remove the sticker covering the transportation lock on the bottom of the
scanner. Then slide the lock to the unlock position, as shown below.
Caution: Do not turn the scanner over; this may damage the scanner.
Power cord and AC adapter
USB cable
™ installs in several steps.
2
Remove the yellow
sticker.
Remove
3
Connect the power cord and AC adapter, as shown. Then connect the AC
adapter to the scanner and plug the other end of the power cord into a
grounded electrical outlet.
Caution:
•
It is not possible to change the AC adapter's input or output voltage. If the
label on the AC adapter does not show the correct voltage, contact your
dealer. Do not plug in the power cord.
•
Whenever you unplug the scanner, wait at least 10 seconds before
plugging it back in to avoid damaging it.
The scanner turns on and the ] Start button light flashes green. It stops
flashing and turns green when the scanner is ready.
4
Plug the USB cable to the scanner, then to your computer as shown below.
Note: Your scanner may not work correctly if you use a USB cable other than
the one supplied by Epson or if you connect your scanner to a hub system.
5
Restart your system, then remove the CD-ROM.
Scanner Basics
Your First Scan
The ] Start button on your scanner opens
Smart Panel. Here's how you can use this
button and Smart Panel to scan photos
and save them as files.
1
Raise the scanner cover and place
your photo face down on the glass.
Place the document against the
front edge of the scanner glass
and center it on the arrow,
as shown.
Then close the cover.
2
Press the ] Start button on your
scanner.
Note: If you see a message the
first time you press the ] Start
button, select EPSON Smart
Panel for Scanner, click Always
use this program for this
action, then click OK.