Advertisement
4
4. Pull out the handle slowly and remove the lamp case.
5. Insert the new lamp gently into the correct position. Push the lamp bot-
tom to check if it is correctly installed.
6. Tighten the screws you removed in step 3. (Make sure they are fixed firm-
ly.)
7. Close the lamp cover and install the screws from step 2 to install the
cover. (If the lamp cover is not installed correctly the unit will not power
on.)
Using another manufacturers lamp may cause damage to the projector
or lamp.
Make sure the lamp cover is securely fastened. If the lamp cover is not
installed correctly the unit will not power on. If this fault persists contact
an LG Authorized Service Center.
Reset Lamp Time
* You must reset lamp time on the menu after replacing the lamp.
1. Press the ꔉOK button on the projector and ꔉOK button on the remote
control simultaneously (About 5 seconds).
Select
Total Lamp Use Time (Hr)
Current Lamp Use Time (Hr)
Lamp Reset Count
Lamp Use Time Reset?
Left or Right?
Reset [ Left/Right Key ]
Exit [ Back Key ]
2. Press the ∧, ∨, ＜, ＞, ꔉOK button. Lamp time will be reset.
LEFT
600
600
0
Reset
ꔗ
LEFT
ꔃ
Advertisement
