HP StorageWorks EML E Series Replacement Instruction Sheet

Interface manager replacement

Download this manual

StorageWorks

Caution: Parts can be damaged by

electrostatic discharge. Keep parts in their

containers until needed. Ensure that you

are properly grounded when touching

static sensitive components.

Inspect the contents of the kit.

Power off the library.

Stop all library activity and ensure that the

picker is empty.

Set the library power switch at the upper right

corner to the OFF position.

Ensure that all power indicators on the power

supplies are off.

EML E-Series

Interface

Manager

Replacement

Note: This part is not hot-pluggable.

It is necessary to power down the library

to replace this part.

Open the back door

of the library.

Identify the Interface Manager. It is located in the

bottom slot of the base module card cage.

Page 1 EML E-Series Interface Manager StorageWorks Replacement Caution: Parts can be damaged by Note: This part is not hot-pluggable. electrostatic discharge. Keep parts in their It is necessary to power down the library containers until needed. Ensure that you to replace this part. are properly grounded when touching static sensitive components.
Page 2 Removal TO FIBRE CHANNEL CONTROLLERS NETWORK SERIAL STATUS ERROR Use a #2 Phillips screwdriver to loosen the captive screws in the black ejector handles at both ends of the Interface Manager. Push the Remove all cables connected to the Interface ejector handles toward the outside, then pull on Manager, after noting where they are connected.
Page 3 Interface Manager and Command View TL installation guide. Getting help • HP product information: http://www.hp.com/products/tapestorage • HP technical support and phone numbers: http://www.hp.com/support • HP StorageWorks Library and Tape Tools (L&TT) diagnostic software: http://www.hp.com/support/tapetools • Interface Manager and HP StorageWorks Command View TL: http://www.hp.com/support/cvtl...