GE eBike Service Manual page 60

2.b Load Calibration eBike L / eBike EL:
Note: Additional accessories required for load calibration of eBike L / eBike EL:
- 1x calibration stay for eBike L / eBike EL
- 2x calibration support for eBike L/EL
(P/N 2018111-134 SPARE EBIKE L&EL SUPPORT FOR CALIBRATION)
- 8-kg calibration weight for eBike L / eBike EL
(P/N 2018111-135 SPARE EBIKE L&EL CALIBRATION WEIGHT 8KG)
- 2nd persons to assist in lifting the couch ergometer
1. Place the ergometer on a level surface and put it into
operation.
2. Set the back rest of eBike L to an angle of 45° (semi-
recumbent position), using the remote control.
Adjust eBike EL to a lateral tilt of 0°, using the remote control.
Then set the back rest to an angle of 45° (semi-recumbent
position).
3. Turn the front castors of eBike L/EL to the back and lock the
castor brakes (see arrow a. in illustration).
To begin with, lift the eBike L/EL at the front, left hand side
and place the calibration support under the left castor (see
arrow b. in illustration).
Then lift the eBike L/EL at the front, right hand side and
place the calibration support under the right castor.
Caution: The castors must be located between the two
border strips (see arrow c. in illustration).
4. Extend the calibration stay to approx. 835 mm and lock.
5. Hang the hook of the calibration weight adapter into the
eye of the strain gauge return spring and let hang.
6. With the aid of an assistant, lift the couch ergometer eBike
L / EL at the back of the base and position the calibration
stay labelled „rear" (see d. in illustration) to the right of the
center brace below the transverse frame.
Attach the calibration stay to the base, using adhesive tape
(see e. in illustration).
Lift the base a little and wait for the calibration stay to stop
swinging.
Caution: Place a weight (e.g. the tool chest) on the base
plate of the calibration stay.
Caution: Make sure that both sides of the transverse frame
sit in the calibration stay and that the stay itself is in a
stable position.
7. With the aid of the calibration stay, align the bottom edge of
the connection box exactly horizontal.
To do so, open clamping lever g. (see item 6) and adjust top
section.
- 54 -
D: Service Menu
eBike, eBike L, eBike EL 2018112-003 Rev J