Manual feed type
1
2
3
► 1. Nut 2. Nylon cutting head 3. Spindle 4. Hex
wrench
1.
Insert the hex wrench through the hole in the gear
case to lock the spindle. Rotate the spindle until the hex
wrench is fully inserted.
2.
Place the nylon cutting head onto the spindle and
tighten the nut securely by the box wrench.
1
► 1. Box wrench 2. Hex wrench 3. Loosen 4. Tighten
3.
Remove the hex wrench from the gear case.
To remove the nylon cutting head, follow the installation
procedures in reverse.
4
4
3
2
Plastic blade
NOTICE:
Be sure to use genuine Makita plastic
blade.
2
► 1. Plastic blade 2. Spindle 3. Hex wrench 4. Loosen
5. Tighten
1.
Insert the hex wrench through the hole in the gear
case to lock the spindle. Rotate the spindle until the hex
wrench is fully inserted.
2.
Place the plastic blade onto the spindle and
tighten it securely by hand.
3.
Remove the hex wrench from the gear case.
To remove the plastic blade, follow the installation pro-
cedures in reverse.
OPERATION
Adjusting the working position
CAUTION:
Before performing this procedure,
install the battery cartridge(s) to the portable
power pack and finish the adjustments for the
waist belt and shoulder harness. Refer to the
instruction manual of the portable power pack for
detail.
CAUTION:
To prevent unintentional start up,
never turn on the portable power pack throughout
this procedure. The battery cartridge(s) is to be
installed only to obtain the usability with actual weight
balance.
16 ENGLISH
1
4
5
3