Programming The Network Settings - Panasonic KX-TDE100 Getting Started

4.2 Programming the Virtual 16-Channel VoIP Gateway Card
4.2.3

Programming the Network Settings

For successful operation of a VoIP network using the V-IPGW16 card, network settings for the PBX at each
location must be programmed appropriately. For a detailed discussion of related features, refer to the
Feature Guide.
This section details the procedure to programme the network settings for the local PBX. After the
programming for the local PBX has been done, repeat the procedure for the remote PBX with the
appropriate setting values.
The following procedures describe the process of programming the network settings for each numbering
method.
Programming for the PBX Code Method
32 Getting Started for Virtual IP Cards
1. a.
Under Configuration, click Slot.
b.
Move the mouse pointer over the white PBX
image of IPCMPR Virtual Slot at the bottom
of the screen.
c.
Click Select Shelf.
d.
Move the mouse pointer over the installed V-
IPGW16 card to display the menu of options.
e.
Click Port Property.
Confirm that all ports are in service (INS).
Note
When a V-IPGW16 card is installed, 8 ports
(1–8) are available. When two V-IPGW16
cards are installed, 16 ports (1–16) are
available.
2. a.
From the system menu, click CO & Incoming
Call.
b.
Click CO Line Settings.
c.
Type the CO Name and assign an unused
Trunk Group Number to be used for all IP
trunks.
d.
Click OK.