Table of Contents
Advertisement
Mounting into the Rack
When this unit is to be mounted on a EIA 19-inch rack,
use Rack Mount Angles (provided) and 8 Rack Mount
Angle Fixing Screws (provided, M4 X 10)
1. Turn off the power of this unit.
2. Remove four rubber feet by removing four screws on
the bottom of this unit.
3. Place the Rack Mount Brackets on both sides of this
unit and tighten with the eight supplied screws.
4. Install the unit with Rack Mount Brackets in the rack by
using four screws (local procurement).
Fasten four screws.
Cautions :
Do not block the ventilation opening or slot on the cover
to prevent the unit from rising temperature.
Always keep the temperature in the rack within 50°C.
Secure the rear of the unit to the rack by using addition-
al mounting angles (procured locally) when the vibration
is added to the rack.
Remove four Rubber Feet.
Note on Installation :
Be sure to have your dealer install the set. Make sure
that the power switch is OFF and that the power plug
has been pulled out of the electrical outlet in advance.
Precautions for Installation :
keep a space of 5 cm or more.
Keep a space of 5 cm or more on the sides t rear and
top of the set.
5 cm or more
Install the set at a place free of noise.
Noise may interfere if the cables of the set are close to
the house electric wires. In such a case, rewire the set
or change its place.
4
5 cm or more
5 cm or more
Advertisement
Table of Contents
