1 Warning Caution: • Pb free solder has a higher melting point that standard solder; Typically the melting point is 50 - 70°F (30 - 40°C) higher. Please use a soldering iron with temperature control and adjust it to 750 ± 20°F (400 ± 10°C). In case of using high temperature solder- ing iron, please be careful not to heat too long.
Page 4
3.2. Trial Operation (After Checking Troubleshooting Guide) 3.2.1. Assembly • Confirm if there is no gap between housing light and left by pinching lead wires. • Confirm that the tool’s battery terminal connections are not misshapen, dirty (covered with a thin film), or otherwise in need to repair.
4 Disassembly and Assembly Instructions *To assemble the tool, start with 4-7 and proceed to 4-1 4.1. How to removing the housing 4.2. How to remove the interior components 4.3. How to remove the LED light assembly from the module assembly...
Page 6
4.4. Precautions when applying grease to the module assembly’s tact switch 4.5. Precautions when applying grease to the angle adjustment board...
Page 7
4.6. How to attach the adjustment board 4.7. How to attach the convex angle adjustment board...