Cleaning And Maintenance; What To Do If - Electrolux E4WMSTPN1 Manual

8
Best results are achieved on:
• Fresh stains that have not completely set.
• Stains that have been previously washed but not dried in a dryer or ironed.
• Small stains confined to a small area of the garment.
Less efficient on:
• Set-in or old stains.
• Stains that have been previously washed and dried in a dryer or ironed.
• Large stains, spread across a large area of the garment.

8. CLEANING AND MAINTENANCE

Quick cleaning instructions:
1. Disconnect the connector from the Stain Remover Pen.
2. Dry the cup and the base if it has been filled with water.
3. Clean the tip with a damp cloth.
4. Sto the Pen in its cradle and wind the power cord into a coil.
5. Store the unit in a dry and well-ventilated area.
NOTE: Never use abrasives, alcohol, solvents or any other chemicals to clean
the unit.

9. WHAT TO DO IF...

If there is a fault, first try to find a solution in the troubleshooting table below.
If you cannot find a solution to the problem, contact an after sales customer
service centre.
Troubleshooting table
Problem
The unit will not
turn on or has
stopped working
Causes
Pre-set cooldown
activated.
Plug not properly
inserted.
Power button defect.
Solutions
Wait 1 min and resume
operation.
Plug the power cord into
the unit and the plug into
the power outlet.
Contact an authorised
Electrolux service center.