How To Mount Oscillator On Mcu Board - Fujitsu MB95100 Series Application Note

MB2146-09 – Installation Guide
Chapter 3 Setting up the Emulation System
Table 2: Setting of product selector switch

3.3.3 How to mount oscillator on MCU board

Plug crystal oscillator or ceramic resonator into the crystal oscillator mounting
sockets (for the main clock and sub clock) on the MCU board. The MCU board has
one crystal oscillator mounting socket for the main clock (SC1-SC3) and another for
the sub clock (SC4-SC6). To distinguish them from each other, the board has the
"MAIN CLOCK" and "SUB CLOCK" labels printed near the main-clock socket and
sub clock socket, respectively. Mount the crystal oscillator along with two capacitors
on the MCU board. By use of a ceramic resonator these capacitors are nit required.
Capacitor mounting socket* Capacitor mounting socket*
Crystal oscillator mounting socket
Ceramic Crystal
resonator oscillator
*Capacitors are not required if a
ceramic resonator is used!
Figure 8: Crystal or ceramic oscillator mounting
MCU-AN-395002-E-V10 - 12 - © Fujitsu Microelectronics Europe GmbH