Table of Contents
Advertisement
8
configuring all the original repeater identification numbers).
7. Configure DIP switch 8 to match your system.
8. Power up the repeater and perform a Dealer Sensor Test (on the repeater).
9. Perform a Repeater Reception Test on all distant sensors to determine which sensor signals
this repeater is able to receive and retransmit.
For this example, only sensors 3 and 4 passed the test.
Add a second repeater to the system
10. Add ("learn") repeater 2 into the control panel memory.
11. Set the identification number for repeater 2 to "four," which is greater than the identification
number for repeater 1. This ensures that repeater 1 can recognize transmissions from repeater
2.
12. Configure DIP switch 8.
13. Place repeater 2 between repeater 1 and a group of distant sensors.
For this example, sensors 5 and 6 were chosen for use with repeater 2.
14. Perform a Repeater Reception Test between repeater 2 and repeater 1.
15. Perform a Repeater Reception Test on all remaining distant sensors (sensors 5 through 8) to
determine which sensor signals this repeater is able to receive and retransmit.
For this example, only sensors 5 and 6 passed the test.
Add a third repeater to the system
16. Add ("learn") repeater 3 into the control panel memory.
17. Set the identification number for repeater 3 to "six."
18. Configure DIP switch 8.
19. Place repeater 3 between repeater 1 and the remaining distant sensors (sensors 7 and 8).
20. Perform a Repeater Reception Test between repeater 3 and repeater 1.
21. Perform a repeater reception test on all remaining distant sensors (sensors 7 and 8) to deter-
mine which sensors this repeater is able to repeat.
For this example, sensors 7 and 8 passed the test.
Specifications
Compatibility:
Euro
Euro Commander panels,
433 MHz Learn Mode sensors and wireless touchpads.
Power Requirements:
220-240VAC, 50 Hz, 75 mA.
A rechargeable12 V lead-acid backup battery is optional.
Fuse:
T32 mA, 250 VAC
Dimensions:
8" x 4.75" x 3.125" (L x W x D), excluding antenna.
SX-V Special (with software 7.0 or later), Euro Concord and
Euro SuperBus
Quik Bridge® Euro Repeater SAW Installation Instructions
®
2000 RF Receiver Module
,
Advertisement
Table of Contents
