Install A Hard Disk, Size 2; Inches Or A Solid State Disk (Ssd) - Fujitsu CELSIUS W570power Operating Manual

Install a hard disk, size 2

EasyChange rails for the hard disk drive are located on the drive cage.
► Open the casing (see
► FUJITSU Workstation CELSIUS W570power+ / W580power+: Open the drive
cage (see "Open the drive cage", Page
"Pull the drive cage out of the casing.", Page
► Place the device on its side as shown below.
1
1
► Secure the EasyChange rails on the side of the hard disk (1) by inserting the upper pins
of the EasyChange rail into the corresponding holes of the hard disk.
► Slide the hard disk drive with the EasyChange rails into the drive cage in the direction
of the arrow (2), until the hard disk is locked in place.
► Connect the cables to the hard disk drive.
► FUJITSU Workstation CELSIUS W570power+ / W580power+: Reinsert the drive
cage into the casing (see
close the drive cage (see
► Close the casing (see
► Position the device vertically again.
If necessary, you must adjust the entry for the drive accordingly in the BIOS setup.
Fujitsu
/

inches or a Solid State Disk (SSD)

1
2
"Opening the casing", Page
38) and pull it out of the casing (see
"Slide the drive cage into the housing.", Page
"Close the drive cage", Page
"Closing the casing", Page
35).
39).
2
41).
36).
System expansions
40) and
61