Bosch Worchester Greenstyle Hanbury 4 Installation, Servicing And User Instructions Manual page 15

INSTALLATION
CHIMNEY CONNECTOR (STOVE PIPE)
The chimney connector should have a dimension of 125mm which
will fit snuggly into the 127mm flue collar of your stove. If this is not
the case, we recommend you contact the dealer in order to ensure
there will be no problem with the draught.
The stove pipe must be made of aluminized or cold roll steel
with a minimum thickness of 0.53 mm. It is strictly forbidden to
use galvanized steel. Stove pipe made from vitreous enamel or
stainless steel is also acceptable.
The stove pipe should be assembled in such a way that the male
section (crimped end) of the pipe faces down. Attach each of the
sections to one another with three equidistant metal screws. Seal
with furnace cement.
Seal Collar with Fire Cement
Self tapping screw
6720819898 C 11/2017
The pipe must be short and straight. Any installation with a
horizontal run of chimney pipe must conform to Document J.
To ensure a good draught, the total length of the connecting flue
pipe should never exceed 2 m.
Installation of a draught damper is not recommended. Indeed, with
a controlled combustion multifuel stove, the draught is regulated
upon intake of the combustion air in the stove and not at the
exhaust.
REAR FLUE PIPE INSTALLATION
• Insert a tee into the flue collar. The tee piece is used as
cleaning access.
• Lift appliance into position. Take care not to damage the
hearth finish.
• Level the appliance
• Connect tee to the chimney using flue pipe
• Secure with self tapping screw
Cap
• Seal the connecting joints
600mm min
1000mm max
unsupported
Self tapping
screw at rear
Seal ue collar with
Fire Cement
To chimney connection
as detailed in building
regulations
Elbow with
access cover
15