Dkey; Dlink [On/Off/Xxxx]; Dmgap [Xx] - GE MDS 4790 Series Installation & Operation Manual

Dekey Transmitter
Diagnostics Link
Diagnostics
Message Gap Time
MDS 05-3438A01, Rev. F
RSPSupply - 1-888-532-2706 - www.RSPSupply.com
http://www.RSPSupply.com/p-8457-MDS-UP-9790X.aspx

DKEY

This command deactivates the transmitter after it has been keyed with
the command. If other keying sources are still active, then the trans-
KEY
mitter will not dekey, but the manual key request is removed.

DLINK [ON/OFF/xxxx]

This command disables or re-enables network-wide diagnostics at the
local radio, and sets the baud rate at the radio's RJ-11
work-wide diagnostics is enabled by default.
Entering enables network-wide diagnostics. Entering
DLINK ON
disables network-wide diagnostics.
DLINK OFF
Use the command locally, at the radio, to enable network-wide
DLINK
diagnostics functionality as well as set the baud rate at the RJ-11
port.
followed by the baud rate sets the baud rate (bps) of the RJ-11
DLINK
port. The following baud rate selections are allowed:
DIAG
• 2400
• 4800
• 9600
• 19200 (default setting)
Example: sets the RJ-11
DLINK 4800
The same baud rate must be entered into the InSite Equipment List's
field.
BAUD
The default setting is
DLINK ON

DMGAP [xx]

The command sets the amount of time in milliseconds to wait
DMGAP
after the receipt of a character before interpreting the next received char-
acter as the start of a new message. When baud rates are slow, the gap
between characters within a poll might be so long that the radio inter-
prets the next character as the start of a new poll. When diagnostics is
performed using passive rather than active messaging (see
Network-Wide Radio Diagnostics" on Page
prevent these errors.
MDS 4790/9790 Series I/O Guide
Manual Key
A
B
port to operate at 4800 bps.
DIAG
.
84), use this command to
screen, Page 72
port. Net-
DIAG
DIAG
"Performing
45