Page 1
Model No. Operating and Installation Instructions ..................2 - 23 Thank you for purchasing the Panasonic product. • This appliance is intended for household use only. • Please read these instructions carefully before attempting to install, operate or service this product.
• The body is deformed or abnormally hot. manufacturer, its service agent or • The Glass Panel is cracked. similarly qualified persons in order Contact a Panasonic Authorised to avoid a hazard. Service Centre immediately for Be sure to disconnect the Power maintenance / repair.
Page 4
Safety Precautions Make sure to follow these instructions WARNING Clean the Power Plug regularly Unattended cooking on a hob with with dry cloth, otherwise, it may fat or oil can be dangerous and may cause insufficient insulation due to result in a fire. moisture, and may cause fire.
Page 5
• Do not use for simmering. The Ceramic Hob with spare parts other ingredients may boil over. than authorised Panasonic parts. • When boiling water, turn down the power level as soon as the water Do not touch the Glass Panel during has boiled.
Parts Identifi cation Parts Identifi cation 1. Cooking Zone 1 (ø 165 mm, 1200 W). 2. Cooking Zone 2 (ø 200 mm, 1800 W). 3. Cooking Zone 3 (ø 165 mm, 1200 W). 4. Cooking Zone 4 (ø 200 mm, 1800 W). 5.
Parts Identifi cation Control Panel Child Lock Cooking Zone 3 Controls Cooking Zone 1 Controls Cooking Zone 4 Controls Cooking Zone 2 Controls OFF/ON Control Programme Time Controls Indicator OFF/ON Light Display Screen 10. Indicator Child Lock Light Shape of the bottom •...
Using the Ceramic Hob Operating the Ceramic Hob Before use • Read this guide, taking special note of the ‘Safety Precautions’ section. • Remove any protective fi lm that may still be on the Ceramic Hob. Using the Touch Controls •...
Using the Ceramic Hob Finish cooking 1. Turn off the cooking zone by touching , or touching simultaneously. 2. Turn off the whole cooking zone by touching the OFF/ON control, Timer Function The timer can be used for either operation below: To set as Reminder.
Using the Ceramic Hob For 2 condition In standby mode, 1. Touch on the cooking zone which is preferable to be used. 2. While the power level indicator is still flashing, touch on the “Programme Time Control” to set the time. (0-99 minutes) 3.
Page 11
Using the Ceramic Hob Auto Shutdown Protection Auto shut down is a safety function for the Ceramic Hob. It shuts down automatically if forgotten to turn off after cooking. The default shutdown time for the various power levels are shown in the below table: Power level Default shutdown time (hours)
Using the Ceramic Hob Cooking Guidelines WARNING Take care when frying as the oil and fat will heat up very quickly, particularly if cooking at high power levels. At extremely high temperatures, oil and fat will ignite spontaneously and this presents a serious fire risk. ■...
Page 13
Using the Ceramic Hob For stir-frying Choose a flat-based wok or a large frying pan. Be ready with all the ingredients and equipment. Stir-frying should be quick. If cooking large quantities, cook the food in several smaller batches. Preheat the pan briefly and add two tablespoons of oil. Cook any meat first, put it aside and keep warm.
Cleaning and Maintenance WARNING Before performing cleaning and maintenance tasks, use isolation switch to disconnect the power supply. Children should not clean the Ceramic Hob or perform maintenance tasks. What Important! Everyday dirt 1. Switch OFF the power. • After the power has been on Glass Panel switched OFF and there are 2.
Page 15
Cleaning and Maintenance Spillovers 1. Switch OFF the power of the • The Ceramic Hob may on the touch Ceramic Hob. beep and turn itself off, and controls. the touch controls may not 2. Absorb the spill with paper or function when there is liquid dry cloth.
Check whether there is a power shortage in home or area. If everything has been checked and the problem still persists, call a Panasonic Authorised Service Centre for assistance. The touch controls are The controls are locked. Unlock the controls. See not responding.
Specifi cations Model KY-R645RLJPQ Electrical Rating Voltage 220 - 240 V 400 V 3N Wattage 5500 - 6600 W 6000 W Frequency 60 Hz Cooking Zones 4 Ceramic Zones Dimension (L × W × H) Approx. 590 mm × 520 mm × 51.5 mm Nett Weight Approx.
Installation Instructions For Installer Safety precautions for installation Please observe these precautions fully WARNING Failure to follow these instructions may cause a risk of personal injury or death. Follow these instructions when The ground should be installed by installing the Ceramic Hob. a qualified electrician.
Page 19
Installation Instructions For Installer CAUTION Failure to follow these instructions may cause a risk of personal injury or death. Use heat resistant materials for the Do not step on or drop any hard work surface. article down on the Glass Panel. The material of the work surface If it is cracked or broken, it may should have the heat resistance...
Installation Instructions For Installer Installation Requirements Cut out the work surface according to the sizes shown in the drawing. For the purpose of installation and use, a minimum of 50 mm space shall be preserved around the hole. Be sure the thickness of the work surface is at least 30 mm. Please select heat-resistant work surface material to avoid larger deformation caused by the heat radiation from the Ceramic Hob.
Page 21
Installation Instructions For Installer Under any circumstances, make sure the Ceramic Hob is well ventilated and the air inlet and outlet are not blocked. Ensure the Ceramic Hob is in a good working state, as shown below. ■ Note: The safety distance for the Ceramic Hob installation as follows: A (mm) B (mm) C (mm)
Page 22
Installation Instructions For Installer Before the Ceramic Hob is installed, make sure that: • The work surface is square and level, and no structural parts interfere with space requirements. • The work surface is made of a heat-resistant material. • If the Ceramic Hob is installed above an oven, the oven has a built-in cooling fan. •...
Installation Instructions For Installer Electrical Connection WARNING This Ceramic Hob must be connected to the main power supply by a suitably qualified person. Before connecting the Ceramic Hob to the main power supply, check that: • The domestic wiring system is suitable for the power drawn by the Ceramic Hob. •...
Page 24
No. 3, Jalan Sesiku 15/2, Section 15, Shah Alam Industrial Site, 40200 Shah Alam, Selangor Darul Ehsan Website: http://www.panasonic.com 16166000A06457 Printed in China G0317-0...