Antenna Connection; Handling The Antenna Cable; Power On / Off - Panasonic TY-FB8TA Operating Instructions Manual

Antenna connection

For proper reception of VHF / UHF channels, an external antenna is required. For best reception, an outdoor
antenna is recommended.
Notes:
• Do not put the Coaxial cable close to the Power cable to avoid noise.
• Do not place the Coaxial cable under the unit.
• Additional equipment, cables and adapter plugs shown are not supplied with this set.
• To obtain optimum quality picture and sound, an Aerial, the correct cable (75 Ω coaxial) and the correct
terminating plug are required.
• If a communal Aerial system is used, you may require the correct connection cable and plug between the wall
Aerial socket and your set.
• Your local Television Service Centre or Dealer may be able to assist you in obtaining the correct Aerial system for
your particular area and the accessories required.
• Any matters regarding Aerial installation, upgrading of existing systems or accessories required, and the costs
incurred, are the responsibility of you, the Customer.

Handling the antenna cable

To avoid noise in the video, hold the antenna cable correctly.
Back
Route away from
the unit.

Power On / Off

Preparation
Connect the mains lead.
Press the switch on the unit to turn the set on.
Owner ID setting screen is displayed. See page 14.
To switch the unit to Standby mode, press the
button on the remote control.
The unit can be switched on by pressing the
again if it was switched to Standby mode.
ANT OUTPUT
75 Ω Coaxial cable
Back
Do not route
close to the unit.
button
switch
VHF Aerial
VCR
ANT INPUT
Front
Do not pass
around the front of
the unit.
Remote control
signal sensor
Power lamp (standby: red)
UHF Aerial
Mixer
OR
5