Bosch MS 6 Manual page 36

4 | Prepare Data Base
4.1.7 Main Data Labels for Injection
4.1.8 Labels to configure Injection during Start
36 / 76
Main Data Labels for Load Calculation
PALTCOR
MP_RL
Notice: For details please refer to the Function Description LOADCALC.
Main Data Labels for injection
CWHPI
CWINJANGMODE
MP_AOINJ
LP-system
HP-system
Notice: Before calibration starts, turn off Lambda closed loop control.
CWLC
Conditions
After initial calibration the start factors for injection may be optimized.
Injection during start conditions
AOINJ_START_NMOT
MP_INJSTART
FINJSTART_TMOT
FINJSTART_NMOT
Notice: For details please refer to the Function Description INJPRECTRL
Engine_Control_Unit_MS_6.x_Manual
Altitude correction for relative load. If unsure, set PALTCOR
to 0.0.
Relative load depending on throttle angle and engine
speed. Set value until your desired Lambda is matched.
Choice LP- or HP battery voltage correction
Choice of angle of injection relation
Map begin/end of injection
Standard choice to end of injection pulse, refers to com-
bustion TDC (degrees before TDC). Make sure, the injec-
tion is finished before the inlet valve closes. Try 200° - 300°
for first startup.
Standard choice to start of injection pulse.
Codeword for enabling of the Lambda closed loop control.
Set to 0 during initial calibration, afterwards = 1
Map begin/end of injection during start
Decay of the start enrichment factor over the number of
engine revolutions
Basic start enrichment factor depending on the engine
temperature
Basic start enrichment factor depending on the engine
speed
Bosch Motorsport