Probe Panel; Figure 5-13 Probe Panel - GE Giraffe Service Manual

Chapter 5: Repair Procedures
5. To remove the EL display, disconnect the electrical connectors, then remove the 2 nuts that hold the display
in place. Be careful not to get finger prints on the display and be sure it is clean before replacing it.
6. The standoffs that hold the back cover also secure the bezel to the front of the module housing. Remove
the standoffs (6mm wrench) and remove the bezel. To replace the membrane switch panel, first disconnect
its electrical connector and then peel it off the display module housing. Be careful to remove all residue
adhesive from the module before installing a new membrane panel. The membrane panel cannot be
repositioned once it has been applied without damaging it.

5.8.2 Probe Panel

Refer to "Figure 5-13 Probe Panel" and "Figure 6-1 Probe Panel Assembly".
Battery holder
88
Battery

Figure 5-13 Probe Panel

6600-0356-000 103
Power switch
Probe panel housing
Electrical enclosure
© 2001 by Datex-Ohmeda, Inc.. All rights reserved.