Wired Network Setup - LG HR500 Owner's Manual

Wired Network Setup

If there is a DHCP server on the local area
network (LAN) via wired connection, this player
will automatically be allocated an IP address.
After making the physical connection, a small
number of home networks may require the
player's network setting to be adjusted. Adjust
the [NETWORK] setting as follow.
Preparation
Before setting the wired network, you need to
connect the broadband internet to your home
network.
1. Select [Connection Setting] option in the
[Setup] menu then press ENTER ( ).
2. The [CONNECTION SETTING] menu appear
on the screen. Use U / u to select the [Wired]
and press ENTER ( ).
3. Use U / u / I / i to select the IP mode
between [Dynamic] and [Static].
Normally, select [Dynamic] to allocate an IP
address automatically
NOTE
If there is no DHCP server on the network and you
want to set the IP address manually, select [Static]
then set the [IP Address], [Subnet Mask], [Gateway]
U / u / I / i
and [DNS Server] using
buttons. If you make a mistake while entering a
number, press CLEAR to clear the highlighted part.
4. Select [OK] and press ENTER ( ) to apply
network settings.
5. The unit will ask you to test the network
connection. Select [OK] and press ENTER
( ) to complete the network connection.
6. If you select [Test] and press ENTER ( )
at step 5 above, the network connection
status is displayed on the screen.
You can also test it on the [Connection
Status] in the [Setup] menu.
Installation 21
3
and numerical