GE CModel C-RS Installation Manual page 38

6.3 Mounting Transducers into the GCF (cont.)
When using the GCF on a pipe subject to mechanical vibration, the locking nut must be used to secure the
IMPORTANT:
pressure bolt to the transducer. For additional resistance to vibration a thread lock compound or a
stainless steel washer and lock washer may also be used. These items can be ordered from GE by
requesting a "special" clamping fixture and specifying either the thread lock or the washers.
See typical completed GCF installations in Figure 11.
Note: If you have mounted the transducers into the UCF properly, the two transducer cable connectors will face away
from each other as shown below.
WARNING! Before performing the next step, make sure power to the flowmeter electronics has been
disconnected.
7. Make the transducer cable connections as described in the flowmeter User's Manual.
30
Double-Traverse Installation (Top View)
Single-Traverse Installation (Top View)
Figure 11: Completed GCF Installations with Transducers
C-RS Ultrasonic Flow Transducer Installation Guide