Table of Contents
Advertisement
30
Settings
[Network] settings
If there is a DHCP server on the local area network (LAN) via wired connection, this product will be
automatically allocated an IP address. After making the physical connection, a small number of home networks
may require the network setting to be adjusted.
A
B
3
C
NOTE
Notes on internet Connection:
y This product does not support wireless network connection.
y Many network connection problems during set up can often be ixed by re-setting the router or modem.
After connecting the product to the home network, quickly power off and/or disconnect the power cable
of the home network router or cable modem. Then power on and/or connect the power cable again.
y Depending on the internet service provider (ISP), the number of devices that can receive internet service
may be limited by the applicable terms of service. For details, contact your ISP.
y Our company is not responsible for any malfunction of this product and/or the internet connection
feature due to communication errors/malfunctions associated with your broadband internet connection,
or other connected equipment.
Tab [Network] on [Installer Settings]. Current status of the
network connection is displayed.
If you want to connect the EnerVu server, tab [Web server
data upload] to change to [On].
Tab [Web server data upload] again for turning off the option.
[On] : The energy data of the system is saved and uploaded to
the server in every 15 minutes.
[Off] : The energy data of the system is not saved. And it is not
uploaded to the server.
Tab [Test] to check the server connection.
If the [Web server data upload] option is not set to [On], the
data may not uploaded to the server.
Tab [Wired settings]. Wired connection options are displayed.
If [IP Setting] option in [Wired settings] tab is set to [Auto],
this product will be automatically allocated an IP address
from local area network (LAN) via wired connection. You
may need to set network connection manually depending on
the network conditions. In this case, tab [Auto] to change to
[Manual].
Fill in [IP address], [Subnet Mask], [Gateway] and [DNS
address] option manually.
Advertisement
Table of Contents
