Disarming The Security Alarm; Disarming The Alarm When Returning Home - Panasonic 1M Operation Manuals

For apartment building ha d series windea

Table of Contents

Disarming the Security Alarm

Disarm the security alarm for both front door and windows at the same time.

Disarming the Alarm when returning home

If the front door is opened in the security alarm status, the magnet switch is turned on and the security

alarm message "(beep) Security is operating." is played. Perform the following operation within the

preliminary alarm time (approx. 60 seconds).

Press the Disarm button while the

preliminary alarm is sounding

The security number input screen appears.

Perform deactivation within 60 seconds after opening the door The

Note

security alarm will sound if the preliminary alarm time is exceeded.

If no security number is set, the security alarm

status is disarmed. It is not necessary to perform

Step

and the subsequent steps.

Enter the security number

The entered security number is displayed

on the screen. Enter the set security

number.

If you entered the wrong number, touch

Note

All entered numbers will be deleted.

Touch

If the correct security number is entered, the

alarm lamp turns off and the alarm is disarmed.

The message "Security has been turned off."

appears on the screen, and the system enters

the standby status after 3 seconds. Select the

Living Mode If the wrong security number is

entered, the screen goes back to the security

number input screen. In that case, repeat the

procedure from Step

Installer

Setting

It is possible to sound the alarm notification message

when disarming the alarm.

Message details: "Security has been turned off."

Consult with the company that installed the system

or the administrating company.

102

Standby status

FIRE CONFIRM

電源

ガス

留守

警戒

戸締り

FIRE

GAS

NOTHOME

SET

OPEN

POWER

The security alarm indicator

lamp flashing in green

Security number input screen