GE GNPR40L Owner's Manual And Installation Instructions page 11

PROGRAMMING THE CONTROL
The green indicator lights up next to the name of
the active control setting.
Pressing the DOWN button displays the settings
in order. By continuing to press the DOWN
button, the settings start over, beginning with the
time of day. Pressing the UP
settings in reverse order.
To change the settings, press the SET button on
the top right. A digit on the display will start to flash.
If you want to change this number, press the UP
button to increase the number or the DOWN
button to decrease the number.
When the number is correct, press the LEFT
button. The digit to the right will stop flashing and
the next digit to the left starts flashing.
To skip the number without changing, press the LEFT
button. When you reach the far left digit, press
the LEFT button to return to the digit on the right.
NOTE: If you press and hold either the UP
DOWN button for more than 1 second, the
flashing number will increase or decrease at ten
counts per second.
You can only change the flashing digit. Continue
changing numbers until you reach the desired
setting. Press the SET button. The numbers stop
flashing and the control accepts the new settings.
After approximately 30 seconds, the control starts
alternating the display between TIME OF DAY and
CAPACITY.
NOTE: If the new setting is not accepted because it
was outside the allowable range, the old value will
be displayed. Refer to the table guides for correct
settings.
Installation Instructions
PROGRAMMING THE CONTROL
button displays the
or
SET PRESENT TIME OF DAY
PM Indicator
light
Press UP or DOWN
DAY.
1. Press the SET button. The display will show the
time of day with the minutes blinking.
2. Press UP or DOWN
button advances the digit; the DOWN button
moves the digit in reverse.
When the number is correct, press the LEFT
button. The digit to the right will stop flashing and
the next digit to the left starts flashing. You can only
change the flashing number.
If the present time is between noon and midnight,
be sure PM indicator light is on. If the present time is
between midnight and noon, be sure PM indicator
light is off.
To change AM/PM, advance the far left digit. The
digit will alternate between 0 and 1. As the digit
alternates, the PM light will turn on and off.
NOTE: Each press of an UP
changes the digit by one minute. Holding the button
changes the digit at a rapid rate.
3. When the present time is correct, press SET to
accept.
11
button to select TIME OF
button to set. The UP
or DOWN button