Remote Control Transceiver Pcb Installation - Bosch 7 709 003 736 Installation Instructions Manual

Table of Contents

Available languages

Remote control installation

4.1

Remote control transceiver PCB

installation

WARNING: Electrical discharge!

B For safety reasons, disconnect the pow-

er supply to the water heater before per-

forming installation.

Pre-installation preparation

B Loosen the two Philips head screws located on bot-

tom rear of cover.

B Lift front cover upward and remove.

B Remove the three screws from the control unit (Fig. 2,

pos.1).

Fig. 2

B Remove the 6 screws from the back cover of the con-

trol unit, to access the electronic board (PCB) (Fig. 3,

pos.2).

Fig. 3

Remote control transceiver PCB installation

B Place the remote control PCB in the back cover of the

control unit as shown in Fig. 4.

Fig. 4

6720608920-38.1Av

B Connect the supplied cable between the main PCB

and the remote control PCB as shown in Fig. 5.

Fig. 5

6720606990-10.1AL

B Reassemble all parts in the reverse order.

6 720 680 078 (2011/09)

Table of Contents

7 709 003 737 7 709 003 747 7 709 003 756 7 736 500 569