Table of Contents
Advertisement
6.3 Identifying LED status
Nokia RoofTop™ Wireless Router Installation Guide
Each of the three LEDs on the face of the NPU serves a specific purpose
and can assume different states.
LEDs on face of Network/Power Unit
After the installation is finished, ideally the LEDs should indicate the
following:
•
Anchor and network LED solid "ON"
You can also leave the LEDs in the following two states:
•
Anchor and network LED "slow flashing" (the light flashes appr.
three times in five seconds) or
•
Network LED "fast flashing" (the light flashes appr. six times in five
seconds). This state is not recommended and you should leave the
installation at this state only if absolutely necessary.
You should never leave the installation, if the Anchor LED is "fast
flashing". If this is the case and you are not able to fix it, contact the
internet service provider.
Identifying LED status
P o w e r / L A N
A n c h o r
N e t w o r k
42
Advertisement
Table of Contents
