Sent Fax Quality Is Poor; Faxes Are Sent At The Wrong Size - Epson WorkForce Pro WF-4720 series User Manual

User's Guide
❏ If the printer has been set to save received faxes on a memory device, connect the device, in which you have
created a folder to save faxes, to the printer. Once the faxes are saved in the device, they are deleted from the
printer's memory. Make sure that the device has enough available memory and is not write protected.
❏ Even though the memory is full, you can send a monochrome fax by using the Direct Send feature. Or you can
also send a fax by dialing from the external phone device.
❏ If the printer cannot print a received fax due to a printer error, such as a paper jam, the memory full error may
occur. Clear the printer problem, and then contact the sender and ask them to send the fax again.
Related Information
"Sending Faxes Dialing from the External Phone Device" on page 117
&
"Sending Many Pages of a Monochrome Document (Direct Send)" on page 118
&
"Saving Received Faxes in the Inbox" on page 124
&
"Saving Received Faxes in an External Memory Device" on page 125
&
"Saving Received Faxes on a Computer" on page 126
&
"Removing Jammed Paper" on page 176
&

Sent Fax Quality Is Poor

❏ Clean the scanner glass.
❏ Clean the ADF.
❏ Change the Original Type setting on the control panel. If your originals contain both text and photos, select
Photo.
❏ Change the Density setting on the control panel.
❏ If you are not sure about the capabilities of the recipient fax machine, enable the Direct Send feature or select
Fine as the Resolution setting.
If you select Super Fine or Ultra Fine for a monochrome fax, and send the fax without using the Direct Send
feature, the printer may automatically lower the resolution.
❏ Enable the ECM setting on the control panel.
Related Information
"Cleaning the Scanner Glass" on page 150
&
"Fax Settings" on page 128
&
"Cleaning the ADF" on page 148
&

Faxes Are Sent at the Wrong Size

❏ When sending a fax using the scanner glass, place the original correctly aligning its corner with the origin mark.
Select your original size on the control panel.
❏ Clean the scanner glass and the document cover. If there is dust or stains on the glass, the scanning area may
extend to include the dust or stains, resulting in the wrong scanning position or small images.
Related Information
"Placing Originals" on page 49
&
Solving Problems
201