Chapter 3
Checking the Configuration Environment
3.4
LAN Connection Preparation for Operation Management
3.4
LAN Connection Preparation for Operation Management
3.4.1
Completing and Attaching the Network Setting Label
Enter the network setting information on the Network Setting label. Attach the Network Setting label on the
rack wall near the controller enclosure to avoid losing it.
Figure 3.2 Network Setting Label
IP address of MNT port
IP address of FST port
Subnet Mask of FST port
IP address of RMT port
Complete the following items in the Network Setting label.
IP address of MNT port
•
Enter the IP address for the MNT port of the ETERNUS AF. The MNT port is a LAN port that is used to perform
operation management connection.
IP address of FST port
•
This item is not used. No information needs to be entered for this item.
Subnet Mask of FST port
•
This item is not used. No information needs to be entered for this item.
•
IP address of RMT port
Enter the IP address for the RMT port of the ETERNUS AF. The RMT port is a LAN port that is used during
initial setup and to connect to the remote support center.
Network Setting
:
:
.
.
:
.
.
:
FUJITSU Storage ETERNUS AF250 S2, ETERNUS AF250 All-Flash Arrays Configuration Guide (Basic)
Copyright 2017 FUJITSU LIMITED
.
.
41
P3AG-1832-04ENZ0