PWM-T210
Mounting the Display
WARNING: AT LEAST (2) QUALIFIED PERSONNEL ARE STRONGLY RECOMMENDED FOR
INSTALLATION OF THIS PRODUCT. FAILURE TO DO SO COULD RESULT IN
SERIOUS INJURY AND POSSIBLE DAMAGE TO THE FLAT PANEL.
1.
Raise the flat panel with the mounting brackets secured to the flat panel and insert the top and bottom
hooks from each bracket to the rods from the wall plates (Figure 15).
M6 x 30 Lateral
Shift Screw
2. Make any lateral shift adjustments and lock the display in place by tightening the two (2) M6 x 30 (mm)
Phillips screws found on the bottom of the mounting brackets (Figure 16).
CAUTION: Do not over tighten the M6 screws to the rods.
Installation Instructions
Figure 15
Lateral Shift
M6 x 30 Lateral
Shift Screw
Figure 16
Top
Bottom
Page 9